Coleman Camping Equipment 2000000144 User Manual

TM  
EVANSTON 14’ X 12’  
MODEL 2000000144  
To Set Up Tent (continued)  
Before you begin  
8. Assemble the  
interlocking  
Read all instructions before set up.  
• Select a level campsite clear of rocks, branches, and other hard  
or sharp objects, to install your tent.  
shock-corded,  
gray, shorter pole.  
9. Slide pole through  
sleeve on front of  
tent. (Fig. 5)  
WARNING: Keep clear of overhead power lines.  
• Do not set up your tent under trees.  
• For best results in windy conditions, position end of tent into  
the wind.  
• Enlist the help of at least one other person to assist you when  
it is time to assemble the tent.  
Fig. 5  
10. Pull down on pole and  
insert into center pin  
location on side of tent.  
(Fig. 6)  
11. Go to opposite side of  
tent and gradually apply  
pressure to the pole to  
form an arch. Insert the  
pin into the pole.  
Parts and Components  
Description  
Part Number  
Main Poles (2)  
Side Poles (2)  
Rainfly  
9163-1101  
9163-1111  
5010000505  
Fig. 6  
Vertical Hinge Door Pole, Black, short with  
plastic cap tips (1)  
9163-1121  
9163-1171  
12. Attach frame clips along edges of tent  
Hinge Door Pole, Black, long with  
plastic cap tips (1)  
to frame poles. (Fig. 7)  
To Set Up Tent  
Fig. 7  
1. Unfold tent and spread out on a clean, level surface with the  
door facing the desired direction. Unzip door.  
2. Assemble main tent poles by interlocking both longer, black  
shock-corded, poles.  
To Attach Rainfly  
1. Assemble remaining interlocking  
shock-corded rainfly pole (gray pole).  
2. Drape rainfly over tent. Make sure  
end with two flaps is centered over  
the door.  
3. Insert black poles through sleeves in top of tent forming an  
“X” as shown. (Fig. 1)  
Fig. 1  
3. Slide gray pole through sleeve in  
rainfly. (Fig. 8)  
Fig. 8  
4. Insert one end of each rainfly pole  
into remaining pin in front corner  
of tent. Gradually apply pressure  
to other end of pole to form an  
arch & insert into other front pin.  
(Fig. 9)  
4. Insert one end of each black pole into  
pins in rear corners of tent. (Fig. 2)  
Fig. 9  
Fig. 2  
5. Hook clips on elastic loops of  
rainfly onto rings on all four  
corners of the tent. (Fig. 10)  
5. Go to opposite end of each pole and gradually apply pressure  
to the pole forming an arch. Insert the pin into the pole end  
at the tent corners.  
(Fig. 3)  
6. Stretch corners of  
tent until floor is taut  
then hammer stakes  
through loops to  
secure.  
Fig. 10  
6. Secure rainfly with velcro hook & loop ties located on  
underside of fly. (Fig. 11 & 12)  
Fig. 3  
7. Attach frame clips along edges  
of tent to frame poles (Fig. 4)  
Fig. 11  
Fig. 12  
Fig. 4  
(continued on other side)  
 

Conair Refrigerator UGH031 0209 User Manual
Continental Electric Blender CP42148 User Manual
Cub Cadet Lawn Mower 054VT User Manual
Danby Freezer SCF401W User Manual
Digicom Network Router 8E4389 User Manual
D Link Network Router WBR 1310 User Manual
Dukane Projector 8932 User Manual
Frigidaire Clothes Dryer 131842900 9903 User Manual
Furman Sound Power Supply ElitE 20 PF User Manual
Gefen Switch EXT DVI 441DL User Manual